Select Page
CDR Repowering Rig

CDR (Crash Data Retrieval) Repowering Rig

Our products are used in every state in the U.S., all Canadian Provinces as well as in Australia, Germany, the Grand Cayman Islands, and Korea.

This is the same CDR Repowering Rig currently being offered in the Bosch CDR Tool from Crash Data Group. If you are interested in purchasing a Bosch CDR Tool, please visit www.crashdatagroup.com

Each CDR Repowering Rig kit includes a set of four fuse block adaptors which will fit Micro2, Mini, Micro3 and ATO automotive fuse sockets.

CDR Deluxe Repowering Rig 

CDR Repowering Rig Deluxe

$55.00 per unit

includes a set of four fuse block adaptors which will fit Micro2, Mini, Micro3 and ATO automotive fuse sockets.




CDR Deluxe Repowering Rig

The use of a the CDR repowering rig allows you to provide a source of power directly to a vehicles airbag control module (ACM). This is of value when a vehicles electrical system has been compromised. Alternatively, the ignition may be damaged or there might not be an ignition key available. The CDR deluxe repowering rig has a fused 12-volt plug and approximately 6’ of each wire. The positive wire has inline fuse protection as well and connects to the appropriate size fuse block adaptor. The fuse block adaptor takes the place of the vehicles airbag control module fuse. The negative wire has an alligator clip for connecting to your vehicle ground. The deluxe model has a built-in 12 volt receptacle, thus eliminating the need for a Y-adaptor when also powering the CDR Interface Module. You must supply your own 12-volt source of power for the CDR repowering rig and CDR Interface Module (when applicable).

Note: You must supply your own 12-volt source of power.

Do not use the add to cart button unless the item is being shipped somewhere in the United States or Canada.

For International orders please contact us via email us (using the form at the bottom of the page) as shipping will need to be calculated on a case-by-case basis.

CDR Repowering Power Pack

CDR Repowering Power Pack

$25.00 per unit




CDR Power Pack

It is a common misconception that you need a 12-volt car battery or a booster pack for crash data retrieval. When repowering a vehicles airbag control module you only need a source of 12-volts DC sufficient to power up a few circuits; not enough to attempt to start a car. If you are flying to the crash data retrieval location or simply have to cover a lot of ground at the salvage yard, the CDR Power Pack is the way to go. The power pack uses 8 AA batteries (not included), along with 2 AA battery blanks to supply a source of 12-volts DC. You can also use 10 rechargeable AA batteries to supply a source of 12-volts DC. It supplies enough power for both the CDR repowering rig and the CDR Interface Module at the same time. Batteries can last for up to 50+ downloads*.

*25 tests conducted with PCM/PCM adaptor, 25 tests conducted with Toyota ACM (approx. 9 minutes for imaging)

Do not use the add to cart button unless the item is being shipped somewhere in the United States or Canada.

For International orders please contact us via email us (using the form at the bottom of the page) as shipping will need to be calculated on a case-by-case basis.

FactualDiagrams.com

a division of Kent E. Boots & Assoc.

2351 Sunset Blvd., Ste. #170-562
Rocklin, CA 95765
Voice: (916) 770-9475
Fax: (916) 290-0418

www.factualdiagrams.com

Contact Us

11 + 11 =